View Single Post
Old September 6th, 2016, 01:42 AM   #8
Senior Member
fierocious1's Avatar
Join Date: Apr 2010
Location: Texas
Posts: 3,335

Originally Posted by Sulla View Post
They didnt seem to be damaged after they turned one time they came off fine past all of the outer most threads. It was just getting them started moving at all that was the problem.
probably going to need a small die grinder then. Just cut down the nut until it is gone with out damaging the plate. Tedious process but a lot of people have to do it that way.
fierocious1 is offline   Reply With Quote