View Single Post
Old August 7th, 2014, 08:24 PM   #6
Senior Member
Join Date: Apr 2014
Location: Northeastern Indiana
Posts: 1,332

Originally Posted by Doc Sk8 View Post
OK.. There is always the possibility you have what is known as a tolerance stack up. The hole is most likely threaded to the max dimension for the 5/8 thread (or bigger). Then you run into the possibility that the toe stop stem is machined to the minimum spec (or smaller)... That can make the clamp almost impossible to work. Most often a different stop solves the problem.
Perfect! See my last post, one thing is for sure, I'm getting a different stop.
Derrick is offline   Reply With Quote