View Single Post
Old November 22nd, 2016, 06:30 PM   #4
BigFoot
Senior Member
 
BigFoot's Avatar
 
Join Date: Jun 2012
Location: So Cal
Posts: 101
Default

I think the hub is around 32mm wide. It is side-set to the inside wheel face. That leaves about 12mm of the outside of wheel unsupported by the hub. This is the part to remove. How much to remove is up to you. I cut mine down to 30mm, but that cut into the hub. Thatís not a problem, it just looks ugly. If you narrow them to a meaty 35mm the hub will be untouched.
BigFoot is offline   Reply With Quote