View Single Post
Old September 5th, 2016, 10:26 PM   #2
Gee
Senior Member
 
Gee's Avatar
 
Join Date: Aug 2016
Location: USA
Posts: 196
Default

Quote:
Originally Posted by Sulla View Post
I have some Suregrip Rebels with the avenger plates I picked up for the plates. A couple of the bolts are just turning in the shoe. A couple more I got off by just getting something between the plate and the boot to give it a little pressure but its not working on these.

At the moment I have some penetrating oil on them then will try later.

Next step will probably be the Dremel. These boots are rather flexible so looks like there is room to cut the bolt and not touch the plate.

Any one have any other ideas?
A vise-grip may be used to hold the bolt still when the nut is being unfasten. If there is any damage on the bolt thread, it should be at the very end where the bolt was broken. With the bolt held still, you should only need a little force to past the nut through.
__________________
- Just roll with it
Gee is offline   Reply With Quote