boiani mounting bolt size

[werdna9]

I just got some new boiani plates and went to mount them when low and behold the mounting holes are to small for the bolts I had with my suregrip classics. I was dissapointed as I didn't get to skate this weekend. I asked at the rink but they don't have anything different, and I dexided to call Connie's but they couldn't help either.

I thought maybe I should order the Roll line or Atlas mounting kit but want confirmation before I order.

Thanks

[rwsz]

Originally Posted by werdna9

I just got some new boiani plates and went to mount them when low and behold the mounting holes are to small for the bolts I had with my suregrip classics. I was dissapointed as I didn't get to skate this weekend. I asked at the rink but they don't have anything different, and I dexided to call Connie's but they couldn't help either.

I thought maybe I should order the Roll line or Atlas mounting kit but want confirmation before I order.

Thanks

usually you cant reuse bolts anyhow as they are difficult to use the nuts on them again after they been cut or broken off.

the atlas or rolline kit should work or you can go to home depot or lowes and get something that will work. get a stainless steel bolt and go from there. take the plate to make sure it fits the hole. also if you arent worrying about trading or selling the plate you can enlarge the mounting holes in it with a drill bit. good luck

[nbskat8]

PM me your shipping address? I'll send you a set of Italian skate mounting bolts... I have quite a few packs....